Structure made entirely of press-bent galvanized cloth metal composed of: self-supporting upper main crossbar up to W 6000
Vertical uprights 150×250 - 250×250 mm press-bent with shaped sliding guides, cable ducts. Edging by means of blue pvc semi-rigid profile to reduce the wear of the cover
Galvanized tubular winding shaft, rotating on bench supports equipped with self-aligning ball bearings and adequate reinforcements.
Flexible cover made of high-strength polyester fabric, PVC coated in standard colors, self-extinguishing EN 13501-1 equipped with pockets for housing the stiffening profiles, with a transparent window at man height.
Stiffening profiles made of galvanized steel useful to resist the wind thrust according to EN 12424 - CL II
High capacity lifting belts that allow the wrapping of the PVC
End of the cover made of flexible material inserted into the cover, PVC pocket for adaptation to the floor and safety sensitive edge
Self-braking three-phase gearmotor unit of adequate power mounted in direct drive, complete with protective cover
Absolute value encoder digital limit switch unit
Control device in IP 55 plastic box, power supply 380V+N+E, multifunctional in accordance with CEI standards with integrated push-button panel, possibility of partial opening, fatliquors monitored by means of LEDs
Unlocking handle for manual emergency opening (in case of black-out or failure)
Safety signs on both sides of the cover with the following indications: "Attention! Automatic door" and "Do not pass with door in motion".